Seiko Is One Of The Few Fully Integrated Watch Manufactures.
(fig.12) 2) the pin is pushed out the opposite side. Make sure to only remove links with screws on the side, the rest of the links are not designed to be removed. Then you need to select a pin on your pin removal tool which is small enough to fit inside it.
I'm Guessing I Just Need To Tap The Pin In The Link In The Direction Indicated By The Arrow?
When they both get squeezed onto each other, they hold the link in place. How to replacing a watch strap with proper watch band tools, watch band spring bar tool, screwdriver, watch band pin and link remover to adjust seiko watch band length, tweezers, magnifier, spring bar bending plier, digital caliper, seiko, bracelet holding block, watch hammer, watch band pin punch. (fig.13) 3) hold the protruding end of the pin with pliers to pull out the pin.
Once In Place, Rotate The Handle Clockwise To Bring The Pusher Towards And Into The Pin Hole.
Then, with the bracelet opened, count down from the break in the bracelet until you have a section of bracelet with as many links you need to remove from this side. Place pin in the hole. Use gentle pressure of pin on the table to push it flush with the bracelet.
A Shot Of The Bottom Of.
It'll pop out, then you can remove the pin which fastens the links. Once the pin has been pushed as far it can go, grip the pin between your fingers. On the side opposite where the spring bar was removed, line up the link connected to the clasp and the second link on the band.
Notice One End Of The Pin Has A Slit In It, Be Sure That The Slit Is On The Opposite End Of The Arrow As You Place The Pins Back In Their Original Position, After You Removed The Desired Amount Of Links.
Afterwards, bend the end link inwards to remove it. Hi, i've just bought a bm and need to remove a few links from the bracelet. Once in place keep rotating the handle until the pin pushes out.
