First Measure Your Wrist With The Wire, And Cut It With Enough Space For The Ring To Fit In The Middle, And Enough On The Ends That You Can Bend The Wire Into A Little Loop On Both Sides.
Learn how to make your own bracelets with these 50 unique project ideas! Cut any excess chain off of the sides if necessary to fit. Try on your hand bracelet.
This Is Here Another Beautiful And Smart Diy Bracelet Project That Everyone Can Do!
This will make it easier to take the bracelet on and off. I wanted a fairly tight fit, but not cutting off my circulation. Add the clasp to the end of on of the 1.5 pieces.
Once Wrapped Back Under My Wrist, I Used Tape To Hold It In Place So I Could Check Fit And Mark The Holes.
At that point cut the chain into two equivalent amounts. Make this bracelet using leather and pewter, will be the best accent to wrap around your wrist. “take your chain and measure your wrist.
Diy Slave Bracelet/Ring Wrist Bracelet.
Then wrap each side down and back under you wrist. Slave bracelet / wrist ring bracelet ♥ diy. And the two equal dangling parts i measured till my wrist, where they would join the bracelet.
Now I Attached The Two Loose Sides To The Bracelet With The Help Of Jump Rings.
Be sure to like and share this! See more ideas about diy. By ariana wallace • posted in beauty • tagged beauty for.
