Take the length of your leather cord, fold it in half and tie a simple overhand knot, leaving a loop above the knot is large enough to fit your button comfortably through. • leather cord (or any sturdy, thin cord): Place the knotted end next to one end of chain.
Get Smartly Crafty Also With Thread And Leather Cord To Make Very Good Looking Forearm Bracelets!
You need a lot of cord because it runs along each side of the beads. Loop the right cord over both metal strands. Make its length double than the chain’s because you don’t want to be short in the middle of the process.
Reinforce The Knot By Wrapping The Thread In A Figure 8 Around The 2.
The video tutorial assists you in the making process that utilizes amazonite stone beads in 6 mm round, round leather cord and silk beading cord. Here's a classic and fun bracelet using beads, leather cord, and silk beading thread. Weaver a figure eight pattern at least six times, just like you did when you started your bracelet and finish off with a double knot around the cord near the knot in the leather.
Snip The End Of Your Thread.
Diy double wrap leather beaded bracelet: Pull the right tail through and under the loops you’ve wrapped and secure it firmly in place. Thread your needle, then tie the end of the thread just below the knot.
Start With Cutting A Piece Of Leather Cord 30 Inches Long.
For it to wrap around your arm twice, cut 36 inches (91 cm) of cord, and so on. Cut two pieces of colored ropes. Tape one end of each group to make it easier to loop through the chain.
